Steps to create Embroidered Iron on Patches

There was a moment in time when embroidered iron on patches were utilised to mostly cover up holes which may have occurred on a garment. But with a little bit of resourcefulness and imagination you can make use of this patch and add an element of spunk and flair to any outfit which you decide on. It’s not only clothes where you can utilize these patches but these embroidered iron on patches may be used to dress up bags, shoes, pillows, furniture, hat’s�the list can be limitless as your imagination.

If you wish to make personalized patches then you could readily build it yourself. You can aquire most of the items that you need quickly at stores where you could purchase premade patches. The most significant selling point of utilizing an iron on patch is you can spend all the time you want to in making them but need to spend a short amount of time affixing them.

You have got to have your items in place before you begin manufacturing your patch. But before you will get your resources think about the design of the patch that you’d like to make. After you have the layout made to size you must sketch or trace the same to the fabric. Ensure that you don’t embroider the design on the cloth without the hoop so the completed pattern comes out flat. Now place a tear away backing sheet on the wrong side of the patch and fasten the embroidery hoop in place so that the design is taut. You can even use some backing spray to mend your backing paper into position.

Now you can begin embroidering your iron on patch. Be sure that your thread isn’t longer than two feet at one time for you to embroider conveniently and don’t have to bother with unwanted tangles and knots. Now embroider across the design making sure that you set about each length of the thread from the back of the pattern in order for the knots or extra lengths don’t show up in front of the pattern.
After you’ve accomplished embroidering your patch take it out of the hoop and take off the backing paper by tearing it away gently. Take some iron on sticky paper and cut it towards the similar size of your patch. Now place your patch facedown on an ironing board and set the iron on sticky patch glue side down on your patch. Have a clear piece of cloth or paper towel on top of the sheet. Put your iron on the low configuration and iron the adhesive to the patch. It’s also possible to make use of the silk setting on your iron. The paper towel or rag will ensure that none of the glue gets stuck to your iron.

Your embroidered iron on patches could be available to utilize once you complete this phase. Now all that you need to do is peel off the paper backing the adhesive at the rear of the patch, put it where you want to put it and iron it securely in position. Iron the cloth inside out in order that the adhesive gets thoroughly activated and retains the patch in place.